| Mass |
127 kg |
| Size |
1250 mm |
| Surface of rotor |
Coated in black |
| Material of electronics housing |
Die-cast aluminium, coated in black |
| Material of blades |
Die-cast aluminium, coated in black |
| Material of mounting ring |
Steel, galvanised and coated in black plastic (RAL9005) |
| Material of wall ring |
Sheet steel, pre-galvanised and coated in black plastic (RAL 9005) |
| Number of blades |
5 |
| Blade angle |
0° |
| Direction of air flow |
"A" |
| Direction of rotation |
Counter-clockwise, seen on rotor |
| Type of protection |
IP 54 |
| Insulation class |
"F" |
| Humidity class |
F5 |
| Max. permissible ambient motor temp. (transp./ storage) |
+80 °C |
| Min. permissible ambient motor temp. (transp./storage) |
-40 °C |
| Mounting position |
Shaft horizontal or rotor on top |
| Condensate discharge holes |
On the stator side |
| Cooling bore / aperture |
On stator sides |
| Operation mode |
S1 |
| Motor bearing |
Ball bearing |
| Technical features |
- Output 10 VDC, max. 10 mA
- Output 20 VDC, max. 50 mA
- Output for slave 0-10 V
- Input for sensor 0-10 V or 4-20 mA
- External 24 V input (programming)
- External release input
- Alarm relay
- Integrated PID controller
- Motor current limit
- PFC, passive
- RS485 MODBUS RTU
- Soft start
- Control input 2-bit
- Control interface with SELV potential safely disconnected from the mains
- Over-temperature protected electronics / motor
- Line undervoltage / phase failure detection |
| Touch current acc. IEC 60990 (measuring network Fig. 4, TN system) |
<= 3,5 mA |
| Electrical leads |
Via terminal box |
| Motor protection |
Reverse polarity and locked-rotor protection |
| Protection class |
I (if protective earth is connected by customer) |
| Product conforming to standard |
EN 61800-5-1 / CE |
| Approval |
UL 1004-7 + 60730 / GOST / C22.2 Nr.77 + CAN/CSA-E60730-1 |
